image

Electromagnetic Lifter Scrap Lifting Square Shape

Material Handling Magnets

Electromagnetic Lifter For Scrap Lifting Square Shape

Application

This special type of Electromagnetic Lifter is especially used for scrap lifting and requires a continuous D.C. power supply while energized (ON).

The effectiveness of its lifting capacity varies according to the contact area of the scrap. Uneven scrap contact can considerably reduce the practical lifting capacity compared with a solid load.

Performance of Lifter

A lifter rated for 10 tons can lift a 10-ton solid load with 100% close contact. With uneven scrap contact, it may lift approximately 5–10% of its rated capacity, or about 500 to 1,000 kg.

Construction of Electromagnetic Lifter

  • Overall body fabricated from high-permeability steel.
  • Conductor made from enamelled copper wire.
  • Class-H insulation with an FRP winding former.
  • Input: 415 V, three-phase, 50 Hz A.C. supply.
  • Output operating voltage: 220 V D.C.
  • Operation through an operating pendant.

Characteristics of Control Panel

  • Input: 415 V, three-phase, 50 Hz A.C. supply.
  • Output operating voltage: 220 V D.C.
  • Three-phase bridge rectifier using silicon diodes.
  • A.C. and D.C. supply protected using fuses.
  • Three red, yellow and blue (RYB) indicator bulbs.

Scope of Supply & Accessories

Scope of supply:
A) Electromagnetic Lifter
B) Control Panel (Rectifier unit)
C) Operating Pendant

Cable DrumFlexible CablesCable CarriersWire Rope ClampsControl-panel Electrical Spares

Performance of Lifter

Lifting effectiveness varies according to contact between the magnetic face and lifting object. A 10-ton lifter with 100% close contact can lift a 10-ton solid load, but scrap has uneven contact and therefore may achieve only a fraction of the total rated capacity.

Scrap Lifting Capacity

Scrap may provide only approximately 5–10% of the lifter's rated capacity. For example, the 10-ton square model may lift approximately 500 to 1,000 kg of scrap. Actual capacity varies with uneven contact area.

Operation Sequence (Follow the steps)

01

Install the control panel on the crane or at a nearby location.

02

Provide the external A.C. supply to the control panel.

03

Connect the control panel to the lifter and operating pendant.

04

Hang the complete lifter assembly from the crane hook.

05

Align the lifter properly on the material to be lifted.

06

Press Magnet ON on the operating pendant to energize the lifter.

07

Lift the scrap to the recommended height.

08

Carry the scrap to the desired place while maintaining minimum height.

09

At the desired place, press Magnet OFF to de-energize the lifter and release the scrap.

Available Sizes

Nominal dimensions are shown as Length × Width × Height. Lifting capacity is specified for 100% close contact. Self-weight is approximate.

Model Code Nominal Size (L × W × H) Lifting Capacity Self Weight (Approx.)
011-04-01 1000 × 1000 × 250 mm 10,000 kg With 100% close contact 2,000 kg
Applications

Applications

Loose parts handling with square electromagnetic scrap lifter
Loose Parts Lifting
Loose pipe pieces held by square electromagnetic lifter
Loose Parts Lifting
Loose machined parts lifted from a bin
Loose Parts Handling
Machined parts handling with square electromagnetic lifter
Machined Parts Handling
Pipe pieces handling with square electromagnetic lifter
Pipe Pieces Handling
Electromagnetic lifter control panel
Control Panel
Operating pendant for magnet and crane
Operating Pendant

Scrap lifting capacity varies according to the uneven contact area between the magnetic face and the material.

Need help choosing a model?

Share your load details with our team.

WhatsApp
Call Us